sonos-play5

Mimoja hat einen Lautsprecher mit Netzwerk, und bastelt daran.

• Großes HF-Shield mit CPU/RAM (HW25000)
  • Freescale MPC8247VRPIEA https://www.nxp.com/docs/en/data-sheet/MPC8272EC.pdf
  • 2x Samsung-RAM, K4S281632-LC75
    • je 128Mbit SDRAM https://pdf1.alldatasheet.com/datasheet-pdf/view/37065/SAMSUNG/K4S281632B/+25177UOYlSuOpdxvZvGvGEEx+/datasheet.pdf
  • Oszillator 100MHz
  • Konnektor J25004, UART, 38400 baud, 3.3V
    • pin 2: TX
    • pin 3: RX
    • pin 4: GND
• Mini-PCI-Slot für WLAN (J25000)
• Großes HF-Shield mit Flash (HW25001)
  • cFeon EN39LV010 https://download.maritex.com.pl/pdfs/sc/EN39LV010.pdf
    • “1 Megabit (128K x 8-bit ) 4 Kbyte Uniform Sector, CMOS 3.0 Volt-only Flash Memory”
  • ST NAND256W3A2BN6 http://pdf1.alldatasheet.com/datasheet-pdf/view/94408/STMICROELECTRONICS/NAND256W3A2BN6.html
    • 256 = 256Mbit
    • W = 3.3V
    • 3 = bus width x8
    • A = 528 Bytes/ 264 Word Page
    • 2 = Chip Enable Don’t Care Enabled
    • B = Second Version
    • N = TSOP48 12 x 20mm (all devices)
    • 6 = –40 to 85 °C
    • blank = Standard Packing
• Oszillator TEUMCK 11.289 (MHz?)
• CIRRUS 5341CZZ 1126 https://statics.cirrus.com/pubs/proDatasheet/CS5341_F2.pdf
• kleines HF-Shield (HW25002):
  • 25MHz-Quarz
  • 2x TERIDIAN 78Q2123, Ethernet-PHYs, http://www.farnell.com/datasheets/38194.pdf
• HanRun HY602458, Ethernet-Spulen
• Konnektor für Buttons (J25002)
• Marvell G16 GOA2R https://datasheet.octopart.com/MDT-G16-A0-Marvell-datasheet-17899646.pdf

• Cirrus Logic CS44800-CQZ https://media.digikey.com/pdf/Data%20Sheets/Cirrus%20Logic%20PDFs/CS44800.pdf
  • 8-Channel Digital Amplifier Controller
  • “The control port has 2 modes: SPI and I2C, with the CS44800 acting as a slave device. SPI mode is selected if there is a high to low transition on the AD0/CS pin, after the RST pin has been brought high. I2C mode is selected by connecting the AD0/CS pin through a resistor to VLC or GND, thereby permanently selecting the desired AD0 bit address state.”
• Oszillator 25.000MHz
• TI N5532 https://www.ti.com/lit/ds/symlink/ne5532.pdf
  • NE5532x, SA5532x Dual Low-Noise Operational Amplifiers

• u-boot 1.1.1
• uart-console
• Pinout:
  • 3.3V
  • RX
  • TX
  • GND
• Early Boot output:

  U-Boot 1.1.1(1-16-4-zp5s-0.5), Build: zp5s-0.5
  
  MPC8272 Reset Status: External Soft, External Hard
  
  MPC8272 Clock Configuration
   - Bus-to-Core Mult 3x, VCO Div 4, 60x Bus Freq  16-50 , Core Freq  50-150
   - dfbrg 1, corecnf 0x10, busdf 3, cpmdf 1, plldf 0, pllmf 3
   - vco_out  400000000, scc_clk  100000000, brg_clk   25000000
   - cpu_clk  300000000, cpm_clk  200000000, bus_clk  100000000
   - pci_clk   33333333
  
  CPU:   MPC8272 (HiP7 Rev 14, Mask unknown [immr=0x0d10,k=0x00e1]) at 300 MHz
  Board: Sonos ZP5S
  DRAM:  32 MB
  IMMR: f0000000
  DRAM tests running ... done
  Using default environment
  
  In:    serial
  Out:   serial
  Err:   serial
  Net:   FCC1 ETHERNET, FCC2 ETHERNET
  Hit any key to stop autoboot:  0 
  NAND ID is 20:75
  32M NAND flash (ST NAND256W3A)
  S0 provisionally good, KP=1, G25
  S1 provisionally good, KP=4, G24
  Boot from partition 1
  ## Starting application at 0x00400000 ..�����������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������..............................
  

• “Hit any key to stop autoboot: 0” sollte kreativ interpretiert werden