Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projekte:monitorwand [2016-03-13 05:03] – clonejo | projekte:monitorwand [2016-05-12 21:05] – [original Bedienpanels] cracki | ||
---|---|---|---|
Line 18: | Line 18: | ||
* wir haben einen Projektantrag gestellt: [[https:// | * wir haben einen Projektantrag gestellt: [[https:// | ||
+ | ===== Bedienpanels ===== | ||
+ | |||
+ | Man will mal die originalen Bedienpanels abknipsen und mit den Steckern etwas bauen, um die Bildschirmgruppen z.B. über Seriell oder CAN zu betreiben (irgendein Bus macht Sinn). Hier die Doku der Bedienpanels. | ||
+ | |||
+ | Das PCB hat gute Beschriftungen. Pin 1 ist an jedem Bauteil ein Punkt, restliche Pins numeriert. | ||
+ | |||
+ | ^ # ^ Farbe ^ Bedeutung ^ | ||
+ | | 1 | schwarz | GND | | ||
+ | | 2 | braun | grüne LED (LED Pin 3) | | ||
+ | | 3 | rot | orange LED (LED Pin 1) | | ||
+ | | 4 | NC | | | ||
+ | | 5 | NC | | | ||
+ | | 6 | blau | Switch 3 | | ||
+ | | 7 | violett | Switch 2 | | ||
+ | | 8 | gruen | Switch 4 | | ||
+ | | 9 | orange | ||
+ | | 10 | gelb | Switch 5 | | ||
+ | |||
+ | Panel: SW1, SW5, LED mit SW4 drunter, SW2, Sw3 | ||
+ | |||
+ | LED: ca 30-50 mA (~2.2-2.5 Volt) sieht gut aus, mehr macht orange zum rot und grün zum orange: | ||
+ | * 1: orange (links) | ||
+ | * 2: GND (mitte) | ||
+ | * 3: grün (rechts) | ||
+ | |||
+ | Switches: einmal fest mit Ground, einmal zum Connector |