Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projekte:monitorwand [2016-03-13 05:03] – clonejo | projekte:monitorwand [2016-07-24 15:35] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 18: | Line 18: | ||
* wir haben einen Projektantrag gestellt: [[https:// | * wir haben einen Projektantrag gestellt: [[https:// | ||
+ | ===== Bedienpanels ===== | ||
+ | |||
+ | Man will mal die originalen Bedienpanels abknipsen und mit den Steckern etwas bauen, um die Bildschirmgruppen z.B. über [[Illuminantibus|Clubbus]] zu betreiben (irgendein Bus macht Sinn). Hier die Doku der Bedienpanels. | ||
+ | |||
+ | Das PCB hat gute Beschriftungen. Pin 1 ist an jedem Bauteil ein Punkt, restliche Pins numeriert. | ||
+ | |||
+ | ^ # ^ Farbe ^ Bedeutung ^ | ||
+ | | 1 | schwarz | GND | | ||
+ | | 2 | braun | grüne LED (LED Pin 3) | | ||
+ | | 3 | rot | orange LED (LED Pin 1) | | ||
+ | | 4 | NC | | | ||
+ | | 5 | NC | | | ||
+ | | 6 | blau | Switch 3 | | ||
+ | | 7 | violett | Switch 2 | | ||
+ | | 8 | gruen | Switch 4 | | ||
+ | | 9 | orange | ||
+ | | 10 | gelb | Switch 5 | | ||
+ | |||
+ | Panel: SW1, SW5, LED mit SW4 drunter, SW2, Sw3 | ||
+ | |||
+ | LED: ca 30-50 mA (~2.2-2.5 Volt) sieht gut aus, mehr macht orange zum rot und grün zum orange: | ||
+ | * 1: orange (links) | ||
+ | * 2: GND (mitte) | ||
+ | * 3: grün (rechts) | ||
+ | |||
+ | Switches: einmal fest mit Ground, einmal zum Connector |