Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
projekte:sonos-play5 [2018-09-16 19:44] – [Hardware] jnprojekte:sonos-play5 [2018-09-17 00:01] – old revision restored (2018-09-17 01:23) Mimoja
Line 25: Line 25:
     * 2x Samsung-RAM, K4S281632-LC75      * 2x Samsung-RAM, K4S281632-LC75 
       * je 128Mbit SDRAM https://pdf1.alldatasheet.com/datasheet-pdf/view/37065/SAMSUNG/K4S281632B/+25177UOYlSuOpdxvZvGvGEEx+/datasheet.pdf       * je 128Mbit SDRAM https://pdf1.alldatasheet.com/datasheet-pdf/view/37065/SAMSUNG/K4S281632B/+25177UOYlSuOpdxvZvGvGEEx+/datasheet.pdf
 +    * Oszillator 100MHz
 +    * Konnektor J25004, UART, 38400 baud
 +      * pin 2: TX
   * Mini-PCI-Slot für WLAN (J25000)   * Mini-PCI-Slot für WLAN (J25000)
   * Großes HF-Shield mit Flash (HW25001)   * Großes HF-Shield mit Flash (HW25001)
Line 40: Line 43:
       * blank = Standard Packing       * blank = Standard Packing
   * Oszillator TEUMCK 11.289 (MHz?)   * Oszillator TEUMCK 11.289 (MHz?)
-  * CIRRUS 5341CZZ 1126+  * CIRRUS 5341CZZ 1126 https://statics.cirrus.com/pubs/proDatasheet/CS5341_F2.pdf
   * kleines HF-Shield (HW25002):   * kleines HF-Shield (HW25002):
     * 25MHz-Quarz     * 25MHz-Quarz
-    * 2x TERIDIAN 78Q2123, vermutlich Ethernet-PHYs+    * 2x TERIDIAN 78Q2123, Ethernet-PHYs, http://www.farnell.com/datasheets/38194.pdf
   * HanRun HY602458, Ethernet-Spulen   * HanRun HY602458, Ethernet-Spulen
   * Konnektor für Buttons (J25002)   * Konnektor für Buttons (J25002)
 +  * Marvell G16 GOA2R https://datasheet.octopart.com/MDT-G16-A0-Marvell-datasheet-17899646.pdf
  
 === Power board === === Power board ===
 +
 +  * Cirrus Logic CS44800-CQZ https://media.digikey.com/pdf/Data%20Sheets/Cirrus%20Logic%20PDFs/CS44800.pdf
 +    * 8-Channel Digital Amplifier Controller
 +    * "The control port has 2 modes: SPI and I2C, with the CS44800 acting as a slave device. SPI mode is selected if there is a high to low transition on the AD0/CS pin, after the RST pin has been brought high. I2C mode is selected by connecting the AD0/CS pin through a resistor to VLC or GND, thereby permanently selecting the desired AD0 bit address state."
 +  * Oszillator 25.000MHz
 +  * TI N5532 https://www.ti.com/lit/ds/symlink/ne5532.pdf
 +    * NE5532x, SA5532x Dual Low-Noise Operational Amplifiers
 +
 +
 +Refer:
 +https://sites.google.com/site/sonosdebug/power-topology
 +=== Logic Connector ===
 +| GND |  1 | 2  | ? | 
 +| GND |  3 | 4  | ? |
 +| GND |  5 | 6  | CAPACITOR to CS44800 VLS |
 +| GND |  7 | 8  | 3.3V |
 +| GND |  9 | 10 | 3.3V |
 +| GND | 11 | 12 | 3.3V |
 +| GND | 13 | 14 | ?    |
 +| GND | 15 | 16 | 12V  |
 +| GND | 17 | 18 | ?    |
 +| GND | 19 | 20 | ?    |
 +| GND | 21 | 22 | ?    |
 +| GND | 23 | 24 | ?    |
 +| GND | 25 | 26 | ?    |
 +| GND | 27 | 28 | SYS_CLK, DAI_MCLK   |
 +| GND | 29 | 30 | GND  |
 +| GND | 31 | 32 | CS44800 LRCLK (in)       |
 +| GND | 33 | 34 | CS44800 DAI_SDIN1 (out)  |
 +| GND | 35 | 36 | CS44800 SDC/CCCLK (out)  |
 +| GND | 37 | 38 | CS44800 SDA/CDOUT (both) |
 +| GND | 39 | 40 | CS44800 INT (in)         |
 +| GND | 41 | 42 | CS44800 RST (out)        |
 +| GND | 43 | 44 | 3.3V |
 +| GND | 45 | 46 | GND  |
 +| GND | 47 | 48 | ?    |
 +| GND | 49 | 50 | ?    |
 +
 +Other reference:
 +https://sites.google.com/site/sonosdebug/board-to-board-connector
 +
 +=== Button board ===
 +
 +==== Software ====
 +=== Bootup ===
 +
 +  * u-boot 1.1.1
 +  * uart-console
 +  * Pinout:
 +    * 3.3V
 +    * RX
 +    * TX
 +    * GND
 +  * Early Boot output: <code>
 +
 +U-Boot 1.1.1(1-16-4-zp5s-0.5), Build: zp5s-0.5
 +
 +MPC8272 Reset Status: External Soft, External Hard
 +
 +MPC8272 Clock Configuration
 + - Bus-to-Core Mult 3x, VCO Div 4, 60x Bus Freq  16-50 , Core Freq  50-150
 + - dfbrg 1, corecnf 0x10, busdf 3, cpmdf 1, plldf 0, pllmf 3
 + - vco_out  400000000, scc_clk  100000000, brg_clk   25000000
 + - cpu_clk  300000000, cpm_clk  200000000, bus_clk  100000000
 + - pci_clk   33333333
 +
 +CPU:   MPC8272 (HiP7 Rev 14, Mask unknown [immr=0x0d10,k=0x00e1]) at 300 MHz
 +Board: Sonos ZP5S
 +DRAM:  32 MB
 +IMMR: f0000000
 +DRAM tests running ... done
 +Using default environment
 +
 +In:    serial
 +Out:   serial
 +Err:   serial
 +Net:   FCC1 ETHERNET, FCC2 ETHERNET
 +Hit any key to stop autoboot: 
 +NAND ID is 20:75
 +32M NAND flash (ST NAND256W3A)
 +S0 provisionally good, KP=1, G25
 +S1 provisionally good, KP=4, G24
 +Boot from partition 1
 +## Starting application at 0x00400000 ..�����������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������..............................
 +
 +</code>
 +
 +=== JTAG ===
 +To be analysed
 +
 +REFER:
 +https://sites.google.com/site/sonosdebug/jtag-connection
 +
 +
Navigation



You are not allowed to add pages